1989 Foxbody Mustang 5.0 LX MANY UPGRADES! (margate) $4900

reply

x prohibited[?]

Posted: 2015-03-09 1:04pm

◀ prev ▲ next ▶

1989 Foxbody Mustang 5.0 LX MANY UPGRADES! – $ 4900 (margate)

< >

1989 foxbody paint color : red size : compact type : hatchback drive : rwd fuel : gas transmission : manual title status : clean cylinders : 8 cylinders

condition: good

  • safety tips
  • prohibited items
  • product recalls
  • avoiding scams

1989 Ford Mustang
ive owned this car since 2004,it has been nothing but reliable.such good motors were produced back in the day.
ive had my fun with it and now i need a quieter automatic daily driver.AC IS ICE COLD!!
Fast foxbody,runs 12’s,turns heads,sounds awesome!!

stock forged bottom end.
cleaned up e7 heads.
B303 cam Ford racing pushrods and lifters.
Edlebrock Performer RPM upper and lower intake port matched,also ported throttle body port to accept 75mm
BBK 225lph intank pump(installed last year)
BBK70MM throttle body
BBK EGR 70MM
C&L 78MM mass air flow.
NEW K&N filter
MSD Cap and rotor
NEW ignition module
ACCEL COIL
BBK 1 5/8 Long Tube Headers (chrome)
Holley Fuel Pressure Regulator
NEW 2 row Aluminum Radiator
NEW water pump
MAC Underdrive pullies
NEW compressor clutch
NEW Rack And Pinion
3G 130A Alternator
94-03 Electric Fan
UPR clutch cable and quadrant
Steeda Tri-ax short throw shifter
Steeda billet shifter boot bezel
Steeda Billet door handles (inside)
Exhaust UPR 3” X-pipe
Dynomax Race Bullets dumped with turn downs.
AUTOMETER fuel pressure gauge mounted to cowl.
AUTOGAGE 5” Monster Tach.
JVC headunit with aux port small 8” subwoofer
3” keanen Cowl hood Freshly Wrapped in gloss black.
FORD RACING aluminum driveshaft
stock T-5 (good condition,4th gear synchro could use replacing as it grinds sometimes)
FMS Cobra Clutch,pressure plate replaced a little over a year ago.
NEW factory replacement ford flywheel.
FMS 4.10 Gears installed about 3 years ago along with new bearings and FMS carrier.
UPR upper and lower control arms
Eibach front sway bar
Steeda subframe connectors welded
torque boxes professionally reinforced.
NEW shocks and Struts
Brakes completely redone about a year ago.
factory springs with 1 coil removed .
10th Anniversary Cobra Replicas from Latemodel restoration purchased with shocks and brakes last year. Staggered deep dish in the rear.

….
now for the bad.
car has typical rust on the hatch (its hard to find a fox without rust there)also a small area under quater window.
the speedometer doesnt work,i swapped my old t5 out for a good one and since then the speedo hasnt worked.about 3 yrs ago.
the cowl panel got bent when the hood was left unlatched last year,so the car needs body work.
power stearing pump is loud and needs a new one.
the seals around the doors could use replacing.florida sun is rough on black seals.
the interior needs a few little things replaced like the ashtray door and pass. side ac vent.(super common and easy to get)
the seats are in fair condition all original carpet and seats.
tires in the front need replacing.

i might be missing a few parts on this list but must see and hear it for yourself! super fun and quite fast.
im well aware of the market of foxbodys and conditions people are asking for theyre cars so im pricing mine at 4900 OBO

  • do NOT contact me with unsolicited services or offers

post id: 4924134867

posted: 2015-03-09 1:04pm

email to friend

best of [?]

Avoid scams, deal locally Beware wiring (e.g. Western Union), cashier checks, money orders, shipping.

  • safety tips
  • prohibited items
  • product recalls
  • avoiding scams

reply

x prohibited[?]

Posted: 2015-03-09 1:04pm

◀ prev ▲ next ▶

1989 Foxbody Mustang 5.0 LX MANY UPGRADES! – $ 4900 (margate)

< >

1989 foxbody paint color : red size : compact type : hatchback drive : rwd fuel : gas transmission : manual title status : clean cylinders : 8 cylinders

condition: good

  • safety tips
  • prohibited items
  • product recalls
  • avoiding scams

1989 Ford Mustang
ive owned this car since 2004,it has been nothing but reliable.such good motors were produced back in the day.
ive had my fun with it and now i need a quieter automatic daily driver.AC IS ICE COLD!!
Fast foxbody,runs 12’s,turns heads,sounds awesome!!

stock forged bottom end.
cleaned up e7 heads.
B303 cam Ford racing pushrods and lifters.
Edlebrock Performer RPM upper and lower intake port matched,also ported throttle body port to accept 75mm
BBK 225lph intank pump(installed last year)
BBK70MM throttle body
BBK EGR 70MM
C&L 78MM mass air flow.
NEW K&N filter
MSD Cap and rotor
NEW ignition module
ACCEL COIL
BBK 1 5/8 Long Tube Headers (chrome)
Holley Fuel Pressure Regulator
NEW 2 row Aluminum Radiator
NEW water pump
MAC Underdrive pullies
NEW compressor clutch
NEW Rack And Pinion
3G 130A Alternator
94-03 Electric Fan
UPR clutch cable and quadrant
Steeda Tri-ax short throw shifter
Steeda billet shifter boot bezel
Steeda Billet door handles (inside)
Exhaust UPR 3” X-pipe
Dynomax Race Bullets dumped with turn downs.
AUTOMETER fuel pressure gauge mounted to cowl.
AUTOGAGE 5” Monster Tach.
JVC headunit with aux port small 8” subwoofer
3” keanen Cowl hood Freshly Wrapped in gloss black.
FORD RACING aluminum driveshaft
stock T-5 (good condition,4th gear synchro could use replacing as it grinds sometimes)
FMS Cobra Clutch,pressure plate replaced a little over a year ago.
NEW factory replacement ford flywheel.
FMS 4.10 Gears installed about 3 years ago along with new bearings and FMS carrier.
UPR upper and lower control arms
Eibach front sway bar
Steeda subframe connectors welded
torque boxes professionally reinforced.
NEW shocks and Struts
Brakes completely redone about a year ago.
factory springs with 1 coil removed .
10th Anniversary Cobra Replicas from Latemodel restoration purchased with shocks and brakes last year. Staggered deep dish in the rear.

….
now for the bad.
car has typical rust on the hatch (its hard to find a fox without rust there)also a small area under quater window.
the speedometer doesnt work,i swapped my old t5 out for a good one and since then the speedo hasnt worked.about 3 yrs ago.
the cowl panel got bent when the hood was left unlatched last year,so the car needs body work.
power stearing pump is loud and needs a new one.
the seals around the doors could use replacing.florida sun is rough on black seals.
the interior needs a few little things replaced like the ashtray door and pass. side ac vent.(super common and easy to get)
the seats are in fair condition all original carpet and seats.
tires in the front need replacing.

i might be missing a few parts on this list but must see and hear it for yourself! super fun and quite fast.
im well aware of the market of foxbodys and conditions people are asking for theyre cars so im pricing mine at 4900 OBO

  • do NOT contact me with unsolicited services or offers

post id: 4924134867

posted: 2015-03-09 1:04pm

email to friend

best of [?]

Avoid scams, deal locally Beware wiring (e.g. Western Union), cashier checks, money orders, shipping.

  • safety tips
  • prohibited items
  • product recalls
  • avoiding scams


View original ad.

Comments are closed.